![]() ![]() This switch will be used perform an off-cycle export of the database and flush all existing data. At the present time, this collection contains a single switch. NetNanny-Switches: A collection of switches.Alerts are triggered when the reported value exceeds: Packet Loss Limit Packet Loss: The packet loss, in percent.Alerts are triggered when the reported value exceeds: Expected Jitter Jitter: The jitter, in milliseconds, of the ping latency results.Alerts are triggered when the reported value exceeds: Expected Latency + (3 * Expected Jitter) Latency: The average ping latency, in milliseconds.Power: A switch, with the name of the Target Destination, that controls the active state of the network performance target. ![]() In addition to the services provided by each network targer, the plugin will adversise an additional a collection of switch services. In an effort to keep outliers from affecting the reported values, the data collected will be run through a filter, as discussed below. All of the data presented for the carbon dioxide sensors is the result of the ping results. Each accessory will advertise four services: (1) switch, and (3) carbon dioxide sensors. The plugin will create, or restore, a dynamic accessory for each network target specified in the configuration. Refer to the section above for specifics on the configuration parameters. It is left to the user to get the plugin up and running within homebridge. If you would rather manually configure and run the plugin, you will find a sample config.json file in the. Indicates which of the Carbon Dioxide sensors issue CO2 aleets when the data exceeds specified limits.īit#0:Time, Bit#1:Packet Loss Bit#2:Standard Deviation Values less than the 'Ping Period' will be ignored. The time, in seconds, over which to filter the ping results. The time, in hours, used to reset the peak values. ![]() The expected jitter, in milliseconds, of the ping latency. The expected latency, in milliseconds, for the ping. The limit, in percent, of lost packets that will be tolerated. Not applicable for gateway or cable_modem Maximum number of result sets to record in the history database The time, in days, for generating report logs of network performance The size, in bytes, of each ping request.Įnables / Disables logging of ping results The number of ping request for each series. The time, in seconds, between each ping request. The time, in seconds, to initiate a series of ping requests. The username (mac address) and port are randomly generaged by homebridge-config-ui-x. ![]() With the child bridge enabled, revisiting the setting page after homebridge is rebooted will show a QR code for pairing to the child bridge. This setting page can be found by clicking on the wrench icon on the plugin and then selecting Bridge Settings. When running under homebridge-config-ui-x, visiting the plugin settings will allow you to change the polling interval and the low space alarm threshold, as shown below.įor details on the configuration settings, please refer to the _Configuration Settings_ section below.Īdditionally, especially if this system will be running other homebridge modules, it is strongly encouraged to run this plugin as an isolated child bridge. This plugin is best experienced when running as a module installed and managed by the homebridge-config-ui-x plugin. Npm install -g homebridge-grumptech-netnanny Configuration homebridge-config-ui-x If using homebridge-config-ui-x, simply search for homebridge-grumptech-netnanny for installation, plug-in management, and configuration. This plug-in is intended to be used with the homebridge-config-ui-x homebridge management tool. Please refer to our security policy for information on which versions are receiving security updates and how to report security vulnerabilities. The change history can be viewed here Security Policy This plugin was inspired by Dave Hamilton's, of the Mac Geek Gab, 3-Ping strategy for evaluating network health. Homebridge Net Nanny, by GrumpTech, is a Homebridge dynamic platform plug-in that publishes metrics measuring the health of a network. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |